Features
| | Compatible with 12V ac adapters |
| | Fully Compliant 802.3af Power Interface Port |
| | 80V, 1 , 400 mA Internal MOSFET |
| | Detection Resistor Disconnect Function |
| | Programmable Classification Current |
| | Programmable Under-voltage Lockout with Programmable Hysteresis |
| | Thermal Shutdown Protection |
| | Auxiliary Power Enable Pin |
| | Current Mode Pulse Width Modulator |
| | Supports both Isolated and Non-Isolated Applications |
| | Error Amplifier and Reference for Non-Isolated Applications |
| | Programmable Oscillator Frequency |
| | Programmable Soft-start |
| | 80% Maximum Duty Cycle Limiter, Slope Compensation (-80 device) |
| | 50% Maximum Duty Cycle Limiter, No Slope Compensation (-50 device) |
General Description
The LM5071 power interface port and pulse width modulation (PWM) controller provides a complete integrated solution for Powered Devices (PD) that connect into Power over Ethernet (PoE) systems. More...
| |
Typical Application
*click for larger image
| Parameters | Values |
| Input Min Voltage |
9.5 Volt |
| Input Max Voltage |
60 Volt |
| Frequency Min |
50 kHz |
| Frequency Max |
1000 kHz |
| Reference Accuracy (+/-) |
2 % |
| Current Draw with AUX Winding (typ) |
0.7 mA |
| Special Features |
Auxiliary power interface, Fully compliant IEEE 802.3af PD interface, Error amplifier for non-isolated designs, leading edge blanking, high current gate drive |
| On/Off Pin |
Yes |
| Error Flag |
Yes |
| Adjustable Output |
Yes |
| Output Min |
1.25 Volt |
| Output Range |
1.25 and above |
| Output Power |
13 Watt |
| Adj Switch Frequency |
Yes |
| Efficiency (peak) |
90.5 % |
| Topology |
Single Ended |
| Flyback |
Yes |
| Inverting |
Yes |
| Step-Up |
Yes |
| Step-Down |
Yes |
| RegType |
Switching Controller |
| Temperature Min |
-40 deg C |
| Temperature Max |
125 deg C |
| PowerWise |
Yes |
Typical Performance
click for larger image
| |
Also Recommended
| LM5068▲ | Negative Voltage Hot Swap Controller |
| LM5070▲ | Integrated Power Over Ethernet PD Interface And PWM Controller |
| LM5072▲ | Higher Transient Voltages (100V), Supplies More Current (750mA) And Compatible With Auxiliary Power |
Additional Resources
Design Tools
Application Notes

Block Diagram
*click for larger image
|