|
Features
Three wideband video amplifiers 110 MHz @ -3 dB (4 VPP output)
TTL OSD inputs, 50 MHz bandwidth
On chip blanking, outputs under 0.1 V when blanked
High speed Video/OSD switch
Independent drive control for each channel for color balance
0V to 4V, high impedance DC contrast control with over 40 dB range
0V to 4V, high impedance DC drive control (0 dB to -12 dB range)
0V to 4V, high impedance DC OSD contrast control with over 40 dB range
Capable of 7 VPP output swing (slight reduction in bandwidth)
Output stage directly drives most hybrid or discrete CRT drivers
Description The LM1282 is a full feature video amplifier with OSD inputs, all within a 28-pin package. This part is intended for use in monitors with resolutions up to 1280 x 1024. The video section of the LM1282 features three matched video amplifiers with blanking. All of the video amplifier adjustments feature high input impedance 0V to 4V DC controls, providing easy interfacing to bus controlled alignment systems. The OSD section features three TTL inputs and a DC contrast control. The switching between the OSD and video section is controlled by a single TTL input. Although the OSD signals are TTL inputs, these signals are internally processed to match the OSD logic low level to the video black level. When adjusting the drive controls for color balance of the video signal, the color balance of the OSD display will track these color adjustments. The LM1282 also features an internal spot killer circuit to protect the CRT when the monitor is turned off. For applications without OSD insertion please refer to the LM1205 or LM1208 data sheets.
Applications
High resolution RGB CRT monitors requiring OSD capability
|
|
