Features 20 to 65 MHz shift clock support Programmable transmitter (DS90C383) strobe select (Rising or Falling edge strobe) Single 3.3V supply Chipset (Tx + Rx) power consumption < 250 mW (typ) Power-down mode (< 0.5 mW total) Single pixel per clock XGA (1024×768) ready Supports VGA, SVGA, XGA and higher addressability. Up to 227 Megabytes/sec bandwidth Up to 1.8 Gbps throughput Narrow bus reduces cable size and cost 290 mV swing LVDS devices for low EMI PLL requires no external components Low profile 56-lead TSSOP package. Also available in a 64 ball, 0.8mm fine pitch ball grid array (FBGA) package Falling edge data strobe Receiver Compatible with TIA/EIA-644 LVDS standard ESD rating >7 kV Operating Temperature: -40°C to +85°C Description The DS90C383 transmitter converts 28 bits of LVCMOS/LVTTL data into four LVDS (Low Voltage Differential Signaling) data streams. A phase-locked transmit clock is transmitted in parallel with the data streams over a fifth LVDS link. Every cycle of the transmit clock 28 bits of input data are sampled and transmitted. The DS90CF384 receiver converts the LVDS data streams back into 28 bits of LVCMOS/LVTTL data. At a transmit clock frequency of 65 MHz, 24 bits of RGB data and 3 bits of LCD timing and control data (FPLINE, FPFRAME, DRDY) are transmitted at a rate of 455 Mbps per LVDS data channel. Using a 65 MHz clock, the data throughputs is 227 Mbytes/sec. The transmitter is offered with programmable edge data strobes for convenient interface with a variety of graphics controllers. The transmitter can be programmed for Rising edge strobe or Falling edge strobe through a dedicated pin. A Rising edge transmitter will inter-operate with a Falling edge receiver (DS90CF384) without any translation logic. Both devices are also offered in a 64 ball, 0.8mm fine pitch ball grid array (FBGA) package which provides a 44 % reduction in PCB footprint compared to the TSSOP package. This chipset is an ideal means to solve EMI and cable size problems associated with wide, high speed TTL interfaces.

Also Recommended DS90CF384A▲ Improved Timing Specs

Typical Application *click for larger image	Block Diagram *click for larger image

Parameters / Values	DS90CF384	DS90CF384A
Function	Receiver	Receiver
Color Depth	24 bpp	24 bpp
Pixel Clock Max	65 MHz	65 MHz
Pixel Clock Min	20 MHz	20 MHz
Compression Ratio	28:4
Output Compatibility	LVCMOS	LVCMOS
Total Throughput	1820 Mbps	1820 Mbps
Payload/Channel	455 Mbps	455 Mbps
Supply Voltage	3.3 Volt	3.3 Volt
Temperature Min	-40 deg C	-10 deg C
Temperature Max	85 deg C	70 deg C
Sensing & Imaging	Yes	Yes
DisplayType	FPD	FPD

Datasheets

Title		Size	Date	Other Language
	DS90CF384 +3.3V LVDS Receiver 24-Bit Flat Panel Display (FPD) Link-65 MHz	365 Kbytes	14-Nov-00	日本語

Application Notes

Title		Size	Date	Other Language
	AN-1032: Application Note 1032 An Introduction to FPD-Link	177 Kbytes	3-Apr-09	日本語
	AN-1163: Application Note 1163 TFT Data Mapping for LDI Dual Pixel Application - Alternate A - Color Map	13 Kbytes	15-May-04
	AN-1056: Application Note 1056 STN Application Using FPD-Link	46 Kbytes	4-Oct-04	日本語
	AN-1085: Application Note 1085 FPD-Link PCB and Interconnect Design-In Guidelines	304 Kbytes	4-Oct-04	日本語
	AN-1127: Application Note 1127 LVDS Display Interface (LDI) TFT Data Mapping for Interoperability with FPD-Link	25 Kbytes	4-Oct-04

Part Number(s) (NSID)	Top View	Availability	Current Reported Stock	Budgetary Pricing	Pack Size
DS90CF384MTD/NOPB DS90CF384MTD RoHS Status	TSSOP	Full production Lead Time: 6 weeks	Distributor Region Qty ARROW Worldwide 185 AVNET-EM Worldwide 170 DIGI-KEY Worldwide 154 MOUSER Worldwide 170 NEWARK Americas 114 TAYLOR Americas 287	$2.40 each at 1K+ pcs	rail of 34
DS90CF384MTDX/NOPB DS90CF384MTDX RoHS Status	TSSOP	Full production Lead Time: 6 weeks	Distributor Region Qty ARROW Worldwide 5000 DIGI-KEY Worldwide 0 MOUSER Worldwide 1000 TAYLOR Americas 5000	$2.40 each at 1K+ pcs	reel of 1000

Obsolete Versions

Obsolete Part	Alternate Part or Supplier	Source	Last Time Buy Date
DS90CF384ASLC	NONE	NONE	03 Mar 2004
DS90CF384ASLCX	NONE	NONE	03 Mar 2004
DS90CF384SLC	NONE	NONE	03 Mar 2004
DS90CF384SLCX	NONE	NONE	03 Mar 2004

All information pertaining to the RoHS Compliance Standard can be found at http://www.national.com/en/packaging/leadfree.html.

Moisture Sensitivity Level Data for DS90CF384.

A RoHS compliance or an IPC 1752 report can be acquired at http://www.national.com/en/packaging/greennopb.html.

National's certificate of product compliance for DS90CF384 is located at RoHS Status.

Part Number(s) (NSID)	Description	Availability	Current Reported Stock	Budgetary Pricing	Pack Size
FLINK3V8BT-85/NOPB	Evaluation Kit for FPD-Link Family of Serializer and Deserializer LVDS Devices	Preliminary Lead Free (RoHS)	Distributor Region Qty AVNET-EM Worldwide 1 DIGI-KEY Worldwide 0 MOUSER Worldwide 2	$500.00 each	1
Description: FPD-Link evaluation kit contains a Transmitter (Tx) board, a Receiver (Rx) board along with interfacing cables. This kit will demonstrate the chipsets interfacing from test equipment or a graphics controller using Low Voltage Differential Signaling (LVDS) to a receiver board. The Transmitter board accepts LVTTL/LVCMOS RGB signals from the graphics controller along with the clock signal. The LVDS Transmitter converts the LVTTL/LVCMOS parallel lines into four serialized LVDS data pairs plus a LVDS clock. The serial data streams toggle at 3.5 times the clock rate. The Receiver board accepts the LVDS serialized data streams plus clock and converts the data back into parallel LVTTL/LVCMOS RGB signals and clock for the panel timing controller. Contents: One Transmitter board with the DS90C385MTD - 28 bit Transmitter One Receiver board with the DS90C386MTD - 28 bit Receiver One 20-pin IDC Flat Ribbon Cable One 60-pin IDC Flat Ribbon Cable Evaluation Kit Documentation DS90C385A/DS90CF386 Datasheet DS90C365A/DS90CF366 Datasheet What the user needs to provide: The user needs to provide the proper RGB inputs and clock to the transmitter and also provide a proper interface from the receiver output to the panel timing controller or test equipment. A cable conversion board or harness scramble may be necessary depending on type of cable/connector interface used. A power down feature is also provided that reduces current draw when the link is not required.

National Semiconductor follows the provisions of the Product Stewardship Guide for Customers (CSP-9-111C1) and Banned Substances and Materials of Interest Specification (CSP-9-111S2) for regulatory environmental compliance. Details may be found at: www.national.com/en/packaging/greennopb.html. Lead free products are RoHS compliant.

Lead Free product status is available through the search tool located here

Part Number(s) (NSID)	Weight (milligrams)	Type	Pins	MSL Rating	Peak Reflow	RoHS Status	CAD Symbols	Models	Package Marking Format
DS90CF384MTD/NOPB DS90CF384MTD	222.11 223	TSSOP	56	2 2	260 235	Detail	Download	ibis file	NS2ZXYTTE# DS90CF384MTD BBBBB
DS90CF384MTDX/NOPB DS90CF384MTDX	222.11 223	TSSOP	56	2 2	260 235	Detail	Download	N/A	NS2ZXYTTE# DS90CF384MTD BBBBB

All information pertaining to the RoHS Compliance Standard can be found at http://www.national.com/en/packaging/leadfree.html.

Moisture Sensitivity Level Data for DS90CF384.

A RoHS compliance or an IPC 1752 report can be acquired at http://www.national.com/en/packaging/greennopb.html.

National's certificate of product compliance for DS90CF384 is located at RoHS Status.

Design Tools

Title	Size	Date
Evaluation Kit for FPD-Link Family of Serializer and Deserializer LVDS Devices

CAD Symbols and Models Download DS90CF384 CAD Symbols

Models ibis file

Reliability Metrics

Part Number	Process	EFR Reject	EFR Sample Size	PPM	LTA Rejects	LTA Device Hours	FITS	MTTF (Hours)
DS90CF384MTD	.35	0	20275	0	0	1515000	3	429885386
DS90CF384MTDX	.35	0	20275	0	0	1515000	3	429885386

Note: The Early Failure Rates (EFR) were calculated as point estimate PPM based on rejects and sample size for EFR. The Long Term Failure Rates were calculated at 60% confidence using the Arrhenius equation at 0.7eV activation energy and derating the assumed stress temperature of 150°C to an application temperature of 55°C.

For more information on Reliability Metrics, please click here.

All information pertaining to the RoHS Compliance Standard can be found at http://www.national.com/en/packaging/leadfree.html.

Moisture Sensitivity Level Data for DS90CF384.

A RoHS compliance or an IPC 1752 report can be acquired at http://www.national.com/en/packaging/greennopb.html.

National's certificate of product compliance for DS90CF384 is located at RoHS Status.

Obsolete Versions

Obsolete Part	Alternate Part or Supplier	Source	Last Time Buy Date
DS90CF384ASLC	NONE	NONE	03 Mar 2004
DS90CF384ASLCX	NONE	NONE	03 Mar 2004
DS90CF384SLC	NONE	NONE	03 Mar 2004
DS90CF384SLCX	NONE	NONE	03 Mar 2004