PowerWise® Design University
Designing with Flat Panel Display Interface
Since the FPD-Link TX includes a PLL type circuit, what is required for the device?
Solid ground
Solid power distribution reference
Vcc noise less than 100 mVpp
All of the above
What is NOT a factor contributing to the skew between two paths in a parallel configuration?
Chip-to-chip skew of the FPD Link transmitter and receivers
Skew of the cable
System skew to the register inputs
All of the above are contributing factors
Why must a termination resistor be used?
To reduce data to data skew
To prevent signal reflections
To increase the stub length
To save PCB space
On the PCB, the Transmitter should be located as close to the interface as possible.
True
False
